What are the precautions for using a coating machine?
Release time:
2020-11-11
Set the coating working methods and related parameters (coating speed, segment length, interval length, roller speed ratio, etc.), and then turn on the compressed air (adjust the compressor box adjustment valve, with the pneumatic pressure between 0.2 and 0.3 MPa).
What are the precautions when using the crystal film coating machine?
3) Set the coating working method and related parameters (coating speed, segment length, interval length, roller speed ratio, etc.), then turn on the compressed air (adjust the compressor box adjustment valve, with pneumatic pressure between 0.2~0.3Mpa).
4) Start the drying fan and the drying temperature controller.
5) Turn on the power for the automatic calibration and tension controller.
6) The temperature of each part of the equipment has reached the process requirement temperature.
7) While providing materials for the coating device hopper, start the crystal film coating machine for coating.
1.3 Shutdown Procedure
1) Confirm whether the coating's extreme point is tangled before stopping the machine.
2) Turn off the power of the equipment heater, stop the drying fan and other fans until the temperature of each section drops below 60 degrees Celsius.
3) Stop the compressed air.
4) Disconnect the power of the calibration cabinet and control cabinet.
1.4 Precautions
1) Operators must receive training before work and pass the exam to perform their duties, and must strictly adhere to this operating regulation.
2) Except for necessary maintenance personnel, it is strictly prohibited for non-designated personnel to operate the equipment or change the setting parameters.
3) It is recommended to set the roller speed ratio within the range of 1.3 to 1.5.
4) The air heater can only be started after the drying fan is turned on.
5) When adjusting the distance between the coating roller and the rear roller, the coating roller's slurry must be wiped, and it should not get stuck on the rear roller, ensuring the parallelism and consistent spacing (there should be a gap) of the two rollers.
6) After resetting parameters, the "Place" button must be pressed to change the parameters.
7) After each shift, the hopper, scraper, coating roller, and other surfaces should be immediately cleaned with alcohol or acetone, and the surfaces must not have scratches or damage.
8) Please pay attention to the cleanliness and lubrication of the rear roller and straight rail.
9) Mechanical bearing parts should be regularly lubricated with oil, and the gearbox should be regularly changed or supplemented with oil.
10) If problems are found during operation, they should be immediately recorded and reported to the relevant department for timely handling.
11) Regularly maintain the 5S work of the equipment, keeping the equipment and surrounding environment clean.
This operating procedure is only applicable to the ST350-III type plate crystal film coating machine.
Coating Process Operating Regulations
2.1 Process Requirements:
1) The length deviation of the first coating is 1mm, and the interval deviation of the coating is 1mm.
2) The maximum error between side 2 and side 1 is 0.5mm.
Thank you all for patiently reading. If you want more knowledge about the crystal film coating machine, feel free to contact us!
Related Information
Beijing XinyiHuida Electromechanical
E-mail: xinyihuida@163.com
Mobile: +86-13911770565 Mr. Lin (General Manager)
Address: 415, 4th Floor, No.2 Jinguangnan Street, Jinguangnan Street, Xilu Street, Fangshan District, Beijing
Product Category
Copyright© Beijing XinyiHuida Electromechanical Equipment Co., Ltd